Reddit reviews Adorox 1 Set of 3pcs (3", 4", 5") Clear Acrylic Display Riser Jewelry Showcase Amiibo Funko POP Figures Store Fixture Table Decorations

I would definitely think about using combat tiers or acrylic display risers to simulate being able to move freely in Limbo. Could also use these risers to simulate debris (e.g., floating rocks and crystal geodes, etc) hurtling across the battle map. Could additionally have tiers of battle maps, representing higher and higher elevations, with the Githyanki fort at the zenith.

I found some rules for ship-to-ship combat here.

I use these, they may not have a height meter but they work well.
Figured i would share them for those of us that are poor. https://www.amazon.com/dp/B015TOTPSE/ref=cm_sw_r_cp_apa_x7cCzbCSTRB2S

I know some people are getting Wave 2 Soon, and with it the Spidicules. The spidicules is one of my favorite showdowns, and unfortunately due to a unwieldy model, doesn't get as much love as it should in my opinion. So I wanted to encourage everyone to try something like this to help them out.

Tools Needed:

• cooking pot
  
• Tongs
  
• Salt
  
• Water
  
• Superglue
  
• A base (mine was the small one of these 3 from: Amazon
  
• Optional: 2-3mm Drill and headpeg: Also Amazon (putting a headpeg and base on the body isnt needed for the final product but it really makes assembly much easier)
  
  I thought this was going to be much harder than it ended up being.
  
  Simply add salt to water(increasing boiling temp), bring it to a near boil, Submerge midsection of the leg you want to alter, then use the tongs to bend it slightly. Be sure not to submerge for too long, and try to keep the part that slides into the body out of the water.
  
  Keep refitting the leg back into the main body and then adjusting it until its about how you want it, then glue it all together.
  
  I previously showed my modded spidicules (sans a pair of legs and paint) but I wanted to help anyone whos getting the model new to have a more enjoyable experience with them.
  
  Feel Free to ask any questions!
  
  Edit: If anyone want to do the headpeg thing. I drilled a hole throughthe assembled body (without Face.) put greenstuff over the hole from the inside. then just glued the flightstand stick into position.
  
  Edit 2: in case anyone tries this, i should mention that the headpeg actually uses 2 of the flight stands glued together.

Make sure you get one of those little plexiglass pedestals, so that it almost looks like the cashews are floating in midair. 😂

The risers I personally use in my detolf are these ones

https://www.amazon.com/gp/product/B015TOTPSE

I have two sets of them. They don't TECHNICALLY let you fit more figures in the case, but they let you rise up figures in the back. Which lets you have more per-shelf without them covering eachother up.

Varying the verticality of each figure helps the display look more dynamic as well. (This would help a lot with your collection especially, since most of your figures are about the same size)