Reddit reviews Arlington 8141 Vertical Siding Lamp Mounting Kit with Built-in Box for 1/2 Inch Vertical Siding LAP
We found 3 Reddit comments about Arlington 8141 Vertical Siding Lamp Mounting Kit with Built-in Box for 1/2 Inch Vertical Siding LAP. Here are the top ones, ranked by their Reddit score.
Kit includes mounting block with built-in electrical box, NM cable connector, and 4 screwsFast and easy to install after siding is upTextured, paintable surfaceBuilt-in electrical box design ensures UL listed installation1/2 Inch Lap
Hi. They make lamp mounting kits for vinyl siding.
Builders Edge 130110006001 Surface Block 001, White https://www.amazon.com/dp/B0041NT7D8/ref=cm_sw_r_cp_api_AV9RAbVRZCPWS
There are different colors. Find one that has the right amount of steps for your type of siding.
Use a outdoor silicon to seal around the edges and there are foam pads you can use between the junction box to the siding cover plate. Hopefully they put a junction box in there, the lamp mount attaches onto the box. If they didn’t, install an outdoor box in there too.
Here is another
Arlington 8141-1 Vertical Siding Lamp Mounting Kit with Built-in Box for 1/2 Inch Vertical Siding LAP https://www.amazon.com/dp/B002W6ZOCO/ref=cm_sw_r_cp_api_4V9RAbFQ3P1Z4
Hope that helps. Turn off the breaker before wiring.
I have mounted things on siding using one of these
https://www.amazon.com/Arlington-Vertical-Siding-Mounting-Built/dp/B002W6ZOCO/
but its plastic and like you said you need to hit a stud especially for a antenna that is heavy and might get wind load.
Thanks for the ideas. I'll have to measure the box on the house and compare it to the one you linked. Maybe your box is large enough to completely cover it and then the current position wouldn't be as much of an issue.
I think the only issue with the cover you linked is that it is for Dutch lap siding. I have hardiplank, so I'm not sure if it will work, since there are difference in how the siding is cut. I might just buy a few different types and see what works best.
One other option I'd rather not do but could be a possibility is to remove that box and install one of these in its place. I'd really rather come up with a solution that uses the existing box instead, but this is always an option.