Reddit reviews DGQ 20 Pack 8mm OD 20mm Long Light Load Compression Mould Die Spring Yellow

Hi I am also a new guy with the Ender3. I think the first thing you should get at the same time as the printer is Filament, because you will only be able to print one or two very little things with the filament provided with the printer.

Then, leveling or 'traming' of the bed is the most critical thing to achieve. After some research here and at other places the general advice is to change the stock springs under the bed get those yellow ones from amazon or other places. The problem with the original ones is that you have to level you bed almost at each print. But the best thing I did to improve the bed leveling issue, is to change the bed surface for a flexible magnetic build surface.

For the rest you will find out by yourself as you gain experience working with your printer. One other thing I did is to change the position of the filament wheel to put it on the side of the printer so that the filament enters more directly in the extruder reducing the angle of penetration to almost 0. For this just download this file from Thingiverse. I will try to get you the link soon.

Hope this will help for a starter.

I got mine from Amazon by typing ender 3 springs. Personally I got this