Reddit reviews HiLetgo 0.1-2000MHz RF WideBand Amplifier 30dB High Gain Low Noise LNA Amplifier
We found 6 Reddit comments about HiLetgo 0.1-2000MHz RF WideBand Amplifier 30dB High Gain Low Noise LNA Amplifier. Here are the top ones, ranked by their Reddit score.
0.1-2000MHz RF Wide Band AmplifierOperating frequency0.1-2000MHzHigh Gain Low Noise LNA AmplifierMaximum power output+10dBm 10mWIt's low in properties can be a perfect match various circuits as ideal amplifier buffer amplifiers.
It's this one. I run antenna -> Band Pass Filter -> Amp -> SDR
Longer antenna cables are always a better idea than longer USB. To do it right, use an amplifier like this on a short cable right after the antenna, but before a long cable run.
To be clear, like this: Antenna -> short cable to amplifier -> amplifier -> long cable to SDR.
USB cables can be chained together to make really long ones, but you get into timing errors and induced noise if you go longer than 16.5 feet. And then, you're really not sure if what you're hearing is real, or an artifact (induced).
Thanks everyone for your insight, this is the LNA I picked up off of Amazon:
https://www.amazon.com/HiLetgo-0-1-2000MHz-Wide-Amplifier-Noise/dp/B01N2NJSGV/ref=sr_1_1?ie=UTF8&qid=1494182132&sr=8-1&keywords=low+noise+amplifier
So far I have to say I'm not seeing much improvement with terrestrial signals from it. I was actually comparing local FM stations with it vs just a basic antenna and it actually seems to be 10 DB less with the LNA powered by 4 AA batteries.
I should be seeing stronger FM signals with the LNA plugged in correct?
Also pick up something like https://www.amazon.com/HiLetgo-0-1-2000MHz-Wide-Amplifier-Noise/dp/B01N2NJSGV or an LNA4HF / LNA4ALL if you want much better performance. :-)
I simply used the HiLetGo model which is .100 KHz to 2 Ghz. I enclosed it, mounted 2 connectors for the case, and a knob to vary the voltage from 12v to 5v providing adjustable gain depending on the need. I didn’t design the preamp or anything, just made it look a little more professional. Here’s the link for the amplifier. The case was taken from my old cell phone site I dismantled but I’m sure there are other aluminum cases out there.
From Amazon:
> When the power supply voltage changes in 5-8 v, it can be used as a variable gain amplifier, gain increases with the increase of the power supply voltage, which suitable for radio frequency receive front-end circuit, using DA control power supply voltage, to control the gain of the amplifier, automatic gain control
> When the power supply voltage in the 8-10 v, the low frequency end gain up to 30 db, at this time the amplifier has a low noise coefficient and good stability.
> When the voltage is 12 v, reach maximum gain, the low frequency end gain of 32.5 dB.
https://www.amazon.com/HiLetgo-0-1-2000MHz-WideBand-Amplifier-Noise/dp/B01N2NJSGV