Reddit reviews Interface Plate Keypin - Wanhao Duplicator i3 Plus/Maker Select Plus
We found 1 Reddit comments about Interface Plate Keypin - Wanhao Duplicator i3 Plus/Maker Select Plus. Here are the top ones, ranked by their Reddit score.
We found 1 Reddit comments about Interface Plate Keypin - Wanhao Duplicator i3 Plus/Maker Select Plus. Here are the top ones, ranked by their Reddit score.
The screen on the plus only really works on the plus, which is why I said replace it. Some have hacked it for use on other printers but it's not really worth it.
I forgot that they use the daughter board on the plus. You could get another daughterboard and use it as a breakout, but its kind of pricey, roughly $20 on ebay/amazon/aliexpress. You would still need short jumper cables to go from this to the board.
https://www.amazon.com/Interface-Plate-Keypin-Wanhao-Duplicator/dp/B07KQQBF89
Personally if I were to fix it then I would cut the end off the connector and extend/crimp the proper connectors on, they need to be JST-XHP. You could buy a kit for $10 and crimpers for <$20. Almost every printer has moved to these connectors so it's generally a good investment for the future.
I had the same thing happen on my non-plus. Replaced the mezli and it died again half a year later when the new board burned up. The entire design of the printer is a pain in the ass. I'd sell it for parts and get a better platform.