Reddit reviews NavePoint Cantilever Server Shelf Vented Shelves Rack Mount 19 Inch 1U Black 14 Inches (350mm) deep

From Amazon, it's a NavePoint 1U Cantilever shelf

This is my new ethernet networking hub in the new house. I had two Cat6 and one RG-6 pulled to every drop and have 14 drops throughout the house. All of the ethernet drops (red and yellow in the top right of the picture) run to this cabinet and the RG-6 go to a panel to the lower right of this with the cable modem and firewall (pfSense). The house is a two story with a walk out basement and this cabinet is in a storage room next the to the stairs in the finished basement.

Equipment:

• Tripp Lite 9U Wall Mount Rack Enclosure, 16.5" Deep, SRW9U
  
• TRENDnet 48-Port Cat6 Unshielded Patch Panel, TC-P48C6
  
• Cisco SG300-52 Managed Switch
  
• D-Link 10-Port Gigabit PoE Switch DGS-1210-10P
  
• Apple Time Capsule (re-capped power supply, reversed and vented fan, WD Red drive)
  
• Sangoma PBX running FreePBX
  
• CyberPower PR1500LCDRT2U Sinewave UPS 1500VA 1350W
  
  Accessories:
  
  
• CyberPower RMCARD205 Remote Management Card
  
• CyberPower ENVIROSENSOR Enviromental Sensor
  
• Monoprice 1000-Feet 23 AWG Cat6 500Mhz UTP CMR Solid Bulk Bare Copper Ethernet Cable - Yellow (108109)
  
• Monoprice 1000-Feet 23 AWG Cat6 500Mhz UTP CMR Solid Bulk Bare Copper Ethernet Cable - Red (108107)
  
• 50M Multimode Duplex 10Gb Fiber Optic Cable (50/125) - LC to LC
  
• LC-LC 10Gb Multimode Duplex 50/125 Fiber Patch Cable, 1FT
  
• TRENDnet Gigabit SFP module, Multi-Mode, Mini-GBIC, Up to 550 m, TEG-MGBSX
  
• Tripp Lite SRCAGENUTS Rack Square Hole Hardware Kit Screws, Washers
  
• Cable Matters Cat6 Ethernet Patch Cable in Black 1 Foot
  
• GearIT Cat6 Ethernet Patch Cable 1.5 Feet - Red
  
• GearIT Cat6 Ethernet Patch Cable 3 Feet - Yellow
  
• NavePoint Cantilever Vented Shelf 1U Black 14" (350mm) deep
  
  Equipment not shown:
  
  
• Leviton 61110-BW6 Extreme Quick Port Connector, White
  
• Leviton 61110-BL6 Extreme Quick Port Connector, Blue
  
• Leviton 41085-MLR Quickport Duplex LC MM Fiber Optic Adapter
  
• Leviton 41091-3WN QuickPort Midsize Wallplate, Single Gang, 3-Port, White
  
• Leviton 41080-4WP QuickPort Wallplate, Single Gang, 4-Port, White
  
• Arlington LV1-10 Low Voltage Mounting Bracket, 1-Gang, Black
  
• Brady PWM-PK-8 B-500 Matte Repositionable Vinyl Cloth Wire Markers
  
  The D-Link is currently for the PoE VoIP phones and PBX. The Cisco switch is for everything else in the house for now. There is a Drobo camping on the top of the cabinet which will be decommissioned eventually and content moved to a FreeNAS server. Current power draw from everything here including Drobo is 85W.
  
  Cross-posted in /r/HomeNetworking
  
  edit: forgot to mention that the fiber line runs to the den where the lab will be setup. Currently the other end is another Cisco SG500-28 (the model without the fans, so quiet). Future upgrade is a 10G connection.

I ordered one of these racks about 2 years ago when I wired up my house and finished my home office:

https://smile.amazon.com/gp/product/B01A6JQV8Y/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

my only hangup on it (and you can actually see it on a review) was that the screws that came with the rack were junk, and I had to go out to get new ones that actually would fit right.


also using:

this patch panel - https://smile.amazon.com/gp/product/B0072K1OWY/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

this shelf - https://smile.amazon.com/gp/product/B008LUW4CI/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

and this cable manager - https://smile.amazon.com/gp/product/B01HJTTOH4/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

​

wish I had photos of the little get-up in my closet for you. I've got a basic 4-outlet battery backup powering my ISP modem, my router, managed 24 port switch, and the seagate single-drive NAS we use.


one day i'd like to get one a bit bigger so it can also support the pi server that's also sitting on that shelf and the POE injectors for my APs.

Maybe a wall mount rack frame + server shelf.