Reddit Reddit reviews Nilight Wiring Harness Kit 14AWG Heavy Duty 12V On-Off Switch Power Relay Blade Fuse for Off Road LED Work Light Bar-ONE Lead,2 Years Warranty

We found 3 Reddit comments about Nilight Wiring Harness Kit 14AWG Heavy Duty 12V On-Off Switch Power Relay Blade Fuse for Off Road LED Work Light Bar-ONE Lead,2 Years Warranty. Here are the top ones, ranked by their Reddit score.

Automotive
Replacement Parts
Automotive Replacement Lighting & Electrical Equipment
Automotive Replacement Electrical Equipment
Automotive Replacement Electrical Wiring Harnesses
Nilight Wiring Harness Kit 14AWG Heavy Duty 12V On-Off Switch Power Relay Blade Fuse for Off Road LED Work Light Bar-ONE Lead,2 Years Warranty
Universal fitment: the wiring harness is compatible with all automobiles, boats and devices equipped with a 12V DC power source12 feet harness: 12ft heavy-duty harness, 14-gauge stranded wire, up to 380W load capacity, the length from relay to switch is extendableIlluminated switch: 3 pin on/off rocker switch with Red Indicator light when truing on, easy to turn on or off, long service lifeCircuit protection: power relay for safety protection. Blade fuse acts as the first Line of defense against overcurrent and short circuitPackage include: 1 x 12 feet wiring harness, 1 x instructions
Check price on Amazon

3 Reddit comments about Nilight Wiring Harness Kit 14AWG Heavy Duty 12V On-Off Switch Power Relay Blade Fuse for Off Road LED Work Light Bar-ONE Lead,2 Years Warranty:

u/TylerTheRoamer · 4 pointsr/CalamariRaceTeam

Use this:

Wiring Harness

u/Schrod1ngers_Cat · 3 pointsr/XVcrosstrek

Parts List:

  1. Attach the clamps to the roof basket.
  2. Mount the light bar to the clamps (I ended up having to buy longer screws than the ones included with the light bar).
  3. Run wiring harness out from under the hood through the drain hole (I had to slightly enlarge the hole with a drill). Slide heat shrink onto the wiring harness, then connect the harness to the light bar via crimping.
  4. Attach the wiring harness to the battery. Test the light bar at this point to ensure everything is functioning correctly. Screw down the relay and seal the heat shrink.
  5. Remove the rubber grommet and run the wiring for the switch through the firewall.
  6. [Optional] The wiring harness comes with a switch, but I wanted to use an OEM switch. I connected the switch listed above to the spare foglight plug using these instructions.
  7. Adjust light bar angle, zip tie any loose wiring and secure the wiring harness to the side of the windshield with silicone sealant (in the drainage channel).

    Hope this helps!
u/tastethepickle · 2 pointsr/chevycolorado

Nilight 10007W 1 Wiring Harness... https://www.amazon.com/dp/B073XMM3T5?ref=ppx_pop_mob_ap_share


Just ran the wiring along others and wired into the fuse block. Switch ran through same hole as the hood release. The switch is the exact size as the hole on the bottom for your steering column. So no drilling and it's out of sight. Absolutely no issues.