Reddit reviews Parafilm M Roll, 250' Length x 2" Width
We found 6 Reddit comments about Parafilm M Roll, 250' Length x 2" Width. Here are the top ones, ranked by their Reddit score.
Parafilm M rollSmall piece of this film will seal test tubes, beakers, flasks, culture tubes, etcMade of a semi-transparent, flexible and waterproof materialResistant to most acids and alcohols yet is gas permeableMeasures 250-feet length by 2-inches width
The roll I bought was only $25 at amazon. That's 250 feet, or enough to wrap 750 plates and comes out to around 3 cents per plate. Not bad IMO.
These are the ones I use Boston Round Bottles and I seal the tops with parafilm though if you can find 1" wide tape instead of 2 that would be better. I normally have to cut the 2" tape in half to wrap the bottles. I've used both kinds of tops and haven't had any leak yet.
edit: format correction
I use this one: https://www.amazon.com/gp/product/B005KDF3X6
But the 1 inch roll would probably work well also.
Parafilm. u/euthanized recommended it to me and I works like a charm.
https://www.amazon.com/gp/aw/d/B005KDF3X6/ref=sxts1?ie=UTF8&qid=1485350007&sr=1&pi=AC_SX236_SY340_QL65
No worries - I've got your Octomore poured. Check out my open inventory and let me know if you see anything else you'd like as a swap for 2 samples of the Kavalan. If not, I'm good just doing the singles. Inventory: https://redd.it/5i7zpv
As for the sample bottles, here's the stuff I use: https://www.amazon.com/dp/B01JL61KNE/ref=cm_sw_r_cp_ep_dp_ApXyyb4Z45MK5
When filling, only fill to the bottom of the neck (just below where the thread starts, and tighten that cap well. You can also use this stuff to put over the top of the cap: https://www.amazon.com/dp/B005KDF3X6/ref=cm_sw_r_cp_ep_dp_OqXyyb0D6A5EN
Get yourself a roll of this:
https://www.amazon.com/Parafilm-Roll-250-Length-Width/dp/B005KDF3X6
Cut a 2 inch square and stretch it over the opening. Keep thumb on top (don't need the lid) and you won't spill a drop. You can even leave it on and put the lid back on, the customer will need to break a little hole in it, but that's easy.