Reddit Reddit reviews TOOGOO(R) Microswitch 15A V-156-1C25 pin plunger snap action (SPDT Micro Switch)

We found 5 Reddit comments about TOOGOO(R) Microswitch 15A V-156-1C25 pin plunger snap action (SPDT Micro Switch). Here are the top ones, ranked by their Reddit score.

Industrial & Scientific
Electronic Components
Electromechanical Products
Switches
Limit Switches
TOOGOO(R) Microswitch 15A V-156-1C25 pin plunger snap action (SPDT Micro Switch)
Size: 27.8x15.9x10mmRoller Diameter: 4.75mmLever Length: 27mmRating: 15A AC250VWithstand Voltage: AC1,0000V 1 Minute
Check price on Amazon

5 Reddit comments about TOOGOO(R) Microswitch 15A V-156-1C25 pin plunger snap action (SPDT Micro Switch):

u/Lordsquiggles7 · 3 pointsr/Nerf

https://www.amazon.com/gp/product/B00K67YO8G/ref=ox_sc_act_title_5?ie=UTF8&psc=1&smid=A3G3SQGWUPUX9W is a switch I've seen used. As long as your batteries don't rhyme with schmustfires.

u/entrluzrnaam · 3 pointsr/Nerf

If you can get a good balancing charger and can be responsible and safe with it, a lipo will definitely be better than IMRs as far as performance goes. If you do go with lipos, you should probably get a better rev switch.

Here's a good rev switch:
https://www.amazon.com/SODIAL-Microswitch-V-156-1C25-plunger-action/dp/B00K67YO8G/ref=sr_1_2?ie=UTF8&qid=1496202242&sr=8-2&keywords=15A+microswitch

And here's a great lipo:
https://www.amazon.com/ZIPPY-Compact-1000mAh-Lipo-Pack/dp/B00TDCDKLW/ref=sr_1_1?ie=UTF8&qid=1496202444&sr=8-1&keywords=zippy+compact+1000mah+3s+25c+lipo+pack

u/K2TheM · 2 pointsr/Nerf

I must be confused about how switches are rated. This was is listed as a 15A rating. Which should be adequate right? Or maybe you were meaning that for the given size of the switch it could have a higher amp rating?

u/DFrostedWangsAccount · 2 pointsr/funny

Well my Stryfe has a pair of MTB Rhino motors instead of the stock ones. They're 12v instead of the 6v stock motors, and run on a 3S LiPo battery instead of the four AAs in series it normally takes.

1.5v * 4 = 6v max vs the LiPo at 12.6v max

I made this to help it fit.

Keep in mind that you need to redo the wiring with something thicker to keep from burning it out. And replace the stock trigger switch with something heavier, I think I used one of these.

I put a little voltage meter on connected to the jam door as well, so I know when it's running low.

So basically I've completely replaced all of the electrical components but it sure hits a lot harder now. You can actually get some decent range from it.

If I wanted to mess with it further I'd probably replace the flywheels with something that could grip a bit better, but the problem I ran into messing with it last time was if they grip too hard they shred darts.