Reddit reviews Trunknets Inc Universal Front Bumper License Plate Bracket + 6 Unique Screws and Wrench Kit

It isn't complicated. You go to your car's dealer, possibly AutoZone, or spend $10 on Amazon and use your own drill. Or look up '[year] [make] [model] front license plate mount'. Literally no excuse to take care of this.

Get this

https://www.ebay.com/itm/mazda-plate-relocator-kit/202611067988?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

and also this

https://www.amazon.com/gp/product/B00RIVG814/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

​

This is what I use on my 2018 3 hatch. At first I used a tow hook license relocator but didn't really like the way the license plate looked offset. The install took about 5 minutes and the most difficult part was lining up the plate that went behind the grill.

I got 2 well nuts & below kit off Amazon:

https://www.amazon.com/gp/product/B00RIVG814/ref=od_aui_detailpages01?ie=UTF8&psc=1

I waited for them to have those in stock for a couple months after I got my '16 WRX (I told my dealer I wouldn't accept the car if it had holes drilled). I got sick of waiting so I did it for a lot cheaper:

Bracket for $10 (cheaper can be had for $5 on there as well but this is what I used)

2 Well nuts and stainless steel screws ($5 at my local Ace Hardware)

so for as little as $10 this can be done if you're willing to put in a small amount of effort. In my case, had other stuff ordered from amazon so I was already paying shipping.. plus I drive by the hardware store every day anyway.




Also the well nuts have a rubber collar that sits between the bracket and the bumper, gently spacing it away from the paint. from the pictures it doesn't look like the adapter foundry one has that