Reddit reviews UNDERSTANDING WOOD FINISHING by BOB FLEXNER
We found 10 Reddit comments about UNDERSTANDING WOOD FINISHING by BOB FLEXNER. Here are the top ones, ranked by their Reddit score.
Bob Flexner has been writing & teaching wood finishing for 18 years.Completely updated second edition of UNDERSTANDING WOOD FINISHING.The most practical, comprehensive book on finishing ever published.
https://www.amazon.com/UNDERSTANDING-WOOD-FINISHING-BOB-FLEXNER/dp/B000H6EJ4U
obligatory post for
http://www.amazon.com/UNDERSTANDING-WOOD-FINISHING-BOB-FLEXNER/dp/B000H6EJ4U
if you want to really understand this subject. get it, read it. I have read it several times.
it's like the bible of finishing.
https://www.amazon.com/dp/B000H6EJ4U/ref=cm_sw_r_cp_apa_8hwjzb789RJCD
This book right here. Everything you need to know about finishing is in this.
Everyone's got to finish their projects, and I've found this book to be such a good resource:
https://www.amazon.com/UNDERSTANDING-WOOD-FINISHING-BOB-FLEXNER/dp/B000H6EJ4U
I respectfully call Bullpucky on that.
"Almost any finishing product – stain, filler, glaze, finish – can be applied successfully over any other finishing product, except wax (including residue wax from paint strippers), as long as that product is dry." - Bob Flexner.
This article is good. His BOOK is even better.
Try:
https://generalfinishes.com/
If you want to really have an idea of what you're doing when finishing, I recommend Understanding Wood Finishing by Bob Flexner
also, check out Understanding Wood Finishes by Bob Flexner amazon link
It's basically an encyclopedia on best practices for finishing and goes through specific techniques for a LOT of different kinds of wood.
Understanding Wood Finishing by Box Flexner has a whole section on French Polishing, well worth a read.
Per Bob Flexner's book,
Warping like this is caused by compression shrinkage. When the wood fibers get wet, especially only on one side, they are limited in their ability to swell laterally, so they well longitudinally. This deforms the fibers, making them longer than they were. They then dry in that long, thin shape, and when they try to return to their original configuration while drying, they are now thinner than they were because of the deformation. This causes them to shrink tighter than they were, pulling the sides of the board into a cup.
The solution to this is counterintuitive but effective. Since you can't fix the wood fibers that have already deformed, you have to deform the other side to match it. Clamp the sides so the wood can't expand in that direction, then soak the bowed (not cupped) side with water and let it dry. You may need to do this several times, but now the fibers on the opposite side will deform, shrink, and pull the board back flat.
It looks like you may need to remove the finish from the top to pull this off, unfortunately, but it's likely the only way to approach a fix without removing wood from the piece. Good Luck!
https://www.amazon.com/UNDERSTANDING-WOOD-FINISHING-BOB-FLEXNER/dp/B000H6EJ4U
Read this. It will help tremendously