Reddit reviews uxcell Rubber Flat Washers 30mm OD 20mm ID 2.3mm Thickness for Faucet Pipe Water Hose, Pack of 20
We found 1 Reddit comments about uxcell Rubber Flat Washers 30mm OD 20mm ID 2.3mm Thickness for Faucet Pipe Water Hose, Pack of 20. Here are the top ones, ranked by their Reddit score.
[Size] - 30mm(1.18 Inch) OD 20mm(0.79 Inch) ID 2.3mm(0.09 Inch) Thickness[Application] - Used for faucet pipe, hose nut, valve, or other gardening maintenance or retrofit[Function] - It can prevent the pipe from leaking and provide positive shut off, stop leaks to save energy[Advantage] - Flexible rubber with high-temperature resistance, anti-corrosion, strong sealing, and can be insulated[NOTE] - Please confirm the required size and material before purchase, and put it in the right place
These plugs:
https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F153104817175
These switches:
https://www.amazon.com/gp/aw/d/B07NTQJ89N?psc=1&ref=ppx_pop_mob_b_asin_image
These gaskets:
https://www.amazon.com/gp/aw/d/B07MHS5BK9?ref=ppx_pt2_mob_b_prod_image
Get a hack saw and cut the 'mushroom top' off the plug. Shove the toggle switch into the resulting pipe (I use the clean end...the slightly jagged cut end will go inside the case). Put two of the gaskets on the pipe. Slide them flush with the toggle button. Insert into the 24mm hole and tighten down with the nut. The gaskets should be on the OUTSIDE of the case and will deform a bit.
You could also use two of the nuts on the same pipe...one inside the case...one outside...if you prefer that look.
Note that for wiring the toggle switches have larger spade connectors than a Sanwa button. I had the proper connectors lying around from my Happ MAME cabinet. You may prefer to solder.