Reddit reviews Wheeler Universal Bench Block with Non-Marring Construction and Multiple Uses for Pistols, Gunsmithing and Maintenance
We found 4 Reddit comments about Wheeler Universal Bench Block with Non-Marring Construction and Multiple Uses for Pistols, Gunsmithing and Maintenance. Here are the top ones, ranked by their Reddit score.
DIMENSIONS: 1 1/4" H x 4" DiameterEASE OF USE: Two-sided tool features all channels and holes needed to add or remove parts from most handgunsVERSATILITY: Works perfectly for assembling and disassembling 1911s as well as 10/22sNON-DESTRUCTIVE: Constructed of non-marring urethaneINCLUDES: Features a main spring removal recess, barrel link removal V channel, rear sight drift channel, front sight stalking channel, hammer and sear pin removal holes, ejector port dressing channel and a rail dressing round bottom channel
I drop oil in the hole and some on the roll pin. Then i use pliars to pinch the end of the roll pin so it starts easier, then I just give it a few good whacks until it can stand in it's own.
Then I use a [Wheeler bench block] (https://www.amazon.com/Wheeler-672215-Universal-Bench-Block/dp/B0047WKF84) and support the end of the barrel with a towel or whatever, just so the gas block will sit solidly on the bench block.
Then whack away with some punches...not too hard.
I used these long roll pin punches:
​
https://www.amazon.com/gp/product/B007WADKN0/ref=oh_aui_detailpage_o05_s01?ie=UTF8&psc=1
and this bench block so I had room to punch the pins the whole way.
https://www.amazon.com/gp/product/B0047WKF84/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
​
and this is the hammer I used (kinda can see it in the picture)
​
https://www.amazon.com/gp/product/B000Z7GGKQ/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
​
​
​
​
I use the Wheeler Set. I would also suggest the Starter Punch from CGW for the more stubborn pins. If you don't have a bench block I would get one of those too. A universal bench block will work fine but I would get the CZ Bench Block to make things a bit easier.
For polishing, some 600 grit, 1000 grit and 2000 grit sandpaper and some diamond stones from brownells would work just fine. Just follow the guides carefully and don't take too much metal off of the crucial areas.
I'd recommend spending the money on a set of Grace USA punches. Bought mine from Amazon and I absolutely love them. I bought these. I also bought this set of Grace roll spring holders. Very useful for starting roll pins. A decent hammer (I have a dedicated brass mallet and a dedicated nylon mallet), and a [bench block]https://www.amazon.com/Wheeler-60981-Universal-Bench-Block/dp/B0047WKF84) if you like things to be easy.
I also have a needle file set (don't remember the brand, but they were like $20 for 6-8 of them). For sanding on the internals I generally just use wet/dry sandpaper. Usually start with around 200-grit, and end with 800-grit. For polishing, Mothers Mag and Aluminum Polish and a white t-shirt. With enough time, it will give a nice mirror finish and be as smooth as ice.