Reddit reviews Wisamic 235x235x4mm Tempered Glass Bed for Creality Ender 3, Ender-3 Pro, Ender-3X, Ender-5, CR-20, CR-20 Pro, Upgraded 3D Printer Build Surface Platform Heated Bed
We found 4 Reddit comments about Wisamic 235x235x4mm Tempered Glass Bed for Creality Ender 3, Ender-3 Pro, Ender-3X, Ender-5, CR-20, CR-20 Pro, Upgraded 3D Printer Build Surface Platform Heated Bed. Here are the top ones, ranked by their Reddit score.
✅ EXCELLENT ADHESION - Covered by microporous coating, this tempered glass heated bed shows strong adhesion in printing. No need to use glue on printing.✅ EASY REMOVAL OF PRINTS - Reduce adhesion after cooling. It is easy to separate the model and the platform and remove the model. Avoid the issue of print edges curling.✅ MORE FLAT FOR PRECISION - Super Flatness. Fast and uniform heating. More precise on printing, especially the bottom of the prints.✅ DURABILITY & EASY CLEAN- The special coating is inorganic and has a hardness of 8 Mohs. Scratch proof and dust proof. It is capable to work at 400oC. Easy clean with alcohol.✅ COMPATIBILITY - Specially designed to fit Creality Ender 3, Ender-3 Pro, Ender-3X, Ender-5, CR-20, CR-20 Pro 3D printer.
Again, I am a super novice...
​
I switched out to a glass bed simply because my stock bed was warped. The tip could touch on the corners and a sheet of paper would slide right through in the center. Once you get the bed level though, I don't think your adhesion problem will be as much of an issue. The magnetic bed it actually pretty nice. I actually ended up turning my bed down a little, to like 55. I was at 60, and it was working, but I was having adhesion problems as well and figured it might be a combination of speed and filament being too hot to stick with a temp that high. I also run my PLA at 210.
​
These springs made leveling the bed much easier. Springs
This was the bed I went with. I like it a lot.
This is the glass I’m using:
Wisamic 3D Printer Heated Bed... https://www.amazon.com/dp/B07H339ZPN?ref=ppx_pop_mob_ap_share
In order, from the top down, I have:
-Textured Ender 3 Pro removable magnetic bed
-Adhesive backed magnetic layer
-Glass bed (linked above)
-3”x3” Silicon pads cut from this material:
uxcell 400mm x 205mm x 0.5mm... https://www.amazon.com/dp/B007PPEW52?ref=ppx_pop_mob_ap_share
-Original adhesive backed magnetic layer (I am testing to see if I could revert to stock at any point, no functional reason)
-Aluminum build plate
Edit: Corrected formatting
I believe because he's using a black-sheer topped glass (it's not clear) the reading looks to be accurate. It's only transparent underneath that black sheer. Here's a linkto the non-monetized glass plate he's using.
That still opens up the "well, maybe your prints are sticking because of that black stuff on top of the glass itself"? Someone will have to try this with transparent glass.
Wisamic 3D Printer Heated Bed 235x235x4mm for Creality Ender 3, Upgraded 3D Printer Platform Tempered Glass Plate Build Surface https://www.amazon.com/dp/B07H339ZPN/ref=cm_sw_r_cp_api_i_BV60Cb0FHDV23