Reddit reviews C2G Single Unit to Go 37133 2-Port RJ45 Splitter/Combiner Cable, Beige 6-Inch
We found 7 Reddit comments about C2G Single Unit to Go 37133 2-Port RJ45 Splitter/Combiner Cable, Beige 6-Inch. Here are the top ones, ranked by their Reddit score.
Note: Sold individually, this item must be used in pairs for each installation, one on each end of the cableThis 2-port passive splitter is handy when you need another network connection but don't have the time or the money to add another cable dropSimply plug one device into your work area network port and another unit to the corresponding patch panel port. Plug and play operation. Supports network speeds up to 100 MbpsNon-intrusive to the networkSpecifications: Connector A: 1 x RJ45 Male, Connector B: 2 x RJ45 Female
Buy a cheap ass-router and one of these and use it to stream porn on you're phone.
Guess someone didn't get the memo
One person can plug-in and you could bridge the connection over wireless I believe. Only downside is that you would need both computers to be there, but you wouldnt have to buy anything assuming both laptops have built-in wireless
Or just one of these guys
You could use one of these but you'll lose gigabit speeds, and drop down to 100Mbps max. You need one on both ends.
Alternatively, depending on how your ISP's equipment is set up, you could connect a managed switch and configure VLANs. This won't work if your ISP's equipment is set up to have only untagged ports.
If you're running a 100Mb/s network, you can actually run two devices at full speed over one cat5(+) cable, as the network connection only uses 4 wires, but the cable contains 8. (You can't do this with gigabit ethernet, it uses all 8 wires)
I found this on Amazon, there are bound to be other places you can get similar. Stick one in your room, and one at your router (you need two connections to the router with this method). Ignore the negative reviews, they are from people who can't follow the simple instructions in my previous sentence.
All the benefits of running 2 separate cables to your room, without the hassle of actually running 2 cables.
Something like this, provided that only jacks on your unit are active. Grab their router and plug it in, make sure that they are on different channels to prevent interference.
If the router is capable of a 'guest' network, it will allow you to effectively have two separate wireless networks, though I am unsure of the security.
Rj45 Splitter
You will only get half the speed of the connected port.
Something like this, https://www.amazon.com/C2G-Cables-37133-Splitter-Combiner/dp/B000Q5UMEI