Reddit reviews Master Airbrush Model TC-828, High-Performance Twin Cylinder Piston Air Compressor with Tank and a Free 6 Inch Airbrush Hose
We found 4 Reddit comments about Master Airbrush Model TC-828, High-Performance Twin Cylinder Piston Air Compressor with Tank and a Free 6 Inch Airbrush Hose. Here are the top ones, ranked by their Reddit score.
Best performing twin piston compressor anywhere! It provides an impressive 46 liters/minute of airflow (1.6 cfm's of air volume), so you can operate 2 airbrushes.Ideally suited for airbrush studios & workshops! Powerful enough to operate low cfm air tools, spray guns and airbrush stationsCompressors large air tank the allows the air to be delivered with constant pressure & zero pulsation!Precise Air Adjustment with true diaphragm pressure regulator with gauge and water trap filter; Portable with the built in handleSupports airbrushing for all airbrush types, applications, paint and color media and levels of users from beginner to advanced artists
Id avoid a bundle because you stuck with one of them being crappy.
When I started, I bought a Badger Cyclone. Solid piece of kit but...no one cares...this is what I use now: Master Airbrush Model TC-828, High-Performance Twin Cylinder Piston Air Compressor with Tank and a Free 6 Inch Airbrush Hose https://www.amazon.com/dp/B006ACBL4Q/ref=cm_sw_r_cp_awd_MyBMwbEKH4EQK
The airbrush Is a very personal choice. If you're really new then learn to maintain on a low-end Badger or Paasche. I used a VL for a very long time till I moved to Iwata.
Either way learning will commence and you'll make smarter choices with more experience. Good luck.
I'm using a Master TC-828 twin-piston tanked compressor. It works great, thus far, and I got it with brush (Master G23) and hose for $180 from TCP Global. (I'd have linked the TCP Global page, but their site is broken at the moment)
It's pretty quiet for a cheap compressor, but it keeps a steady stream of pressure at any setting, turning on when it needs to. It's never shut itself off during a paint session, either. I'm not sure if I'm impressed or concerned. It got pretty hot while I was doing a marathon session on my MG GM Sniper, though maybe not hot enough to trip the safety? It didn't stop working, that's for sure, and it still works just fine. Did a bit of painting with it today for that matter.
Obviously, a good Iwata will be quieter and probably run cooler, but this cost $180 with 6 feet of hose and a gravity-feed airbrush, versus $400 for an Iwata compressor on its own. If this compressor ever gives me a problem, maybe I'll upgrade, but so far it's been very solid.
You can try windex as airbrush thinner. Works fine for me with vallejo and gw paints (which work fine in airbrushes).
That's a lot of coin to drop on a compressor. tbh I don't know what difference you would experience if you went with something like this instead
https://www.amazon.com/dp/B006ACBL4Q?psc=1
Recheck if you need to buy a hose and water trap. The compressor you linked above comes with both and says the hose included "fits Iwata airbrushes" unless you want that braided-ness.
Check the size of the booth or if you can DIY it. It's not very big at all.
Dimensions when Set-Up: 16.5" Wide x 19" Deep x 13.5" High
If you're in 'Murica, those Master compressors seem to be a pretty good bargain.
http://www.amazon.com/Master-Airbrush-High-Performance-Cylinder-Compressor/dp/B006ACBL4Q