Reddit reviews MOTOROLA MoCA Adapter for Ethernet Over Coax 2-Pack, 1,000 Mbps Bonded 2.0 MoCA (Model MM1002)
We found 24 Reddit comments about MOTOROLA MoCA Adapter for Ethernet Over Coax 2-Pack, 1,000 Mbps Bonded 2.0 MoCA (Model MM1002). Here are the top ones, ranked by their Reddit score.
New in 2018, MODEL MM1002 IS A PACK OF TWO (2) MODEL MM1000 MOCA ADAPTERS FOR ETHERNET OVER COAX. Speeds up to 1,000 Mbps! Bonded MoCA 2.0 beats wireless for speed, latency, reliability, and security.Transmits over the same coax cables as your cable TV or fiber-optic service, with no interference. Does not work with satellite, AT&T Internet, and AT&T U-verse coax networks.You need MoCA capability built into your router or provided to the router by a MoCA Adapter. Most FiOS routers have MoCA capability, but most other routers and modem/routers need a MoCA Adapter.You need a MoCA Adapter for each device you want to connect back to the router using MoCA. You can connect up to 16 devices back to your router using MoCA.Easy plug-in setup, with no need for configuring the MoCA Adapter or re-configuring your router. Friendly, professional USA customer support and 2 year warranty.
I agree, you may be better off with Powerline, or even better, Moca if you have a coax port in that basement. See links below:
https://thewirecutter.com/reviews/best-powerline-networking-kit/
https://smile.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/
> Are there any solutions to improve powerline until a better one is established?
Nope. Such is the life of powerline. Erratic behavior is expected.
> Any help would be appreciated.
>
> I read about MoCA, and it sounds like a good, but expensive option (though the coax wiring is even more of a mess the the regual wiring is).
Cable lines are at least designed to carry data while powerlines are not. All you need is a cable connection between two places. It can be split as long as the splitters are of good quality and don't interfere with the MoCA.
This set is an affordable option: https://smile.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/ref=sr_1_3?keywords=motorola+moca&qid=1562258609&s=gateway&sa-no-redirect=1&sr=8-3&x=0&y=0
Basically anything is going to be better than powerline.
You can always use MoCA adapters to get data anywhere you have a coax connection. I hear they can do from 300-700mb of throughput, but I opted to just run some ethernet around walls instead.
Depending on your needs though, would definitely look into getting data drops run to wherever your data goes. Could get pricey if you can't do it yourself, but if you're going to be going for the fastest speeds available from TDS it would absolutely be worth it in the long run.
https://www.amazon.com/dp/B078HMDDVS/ref=cm_sw_em_r_mt_dp_U_LfNMDbAA8B2HY
These bonded 2.0 adapters give close to gigabit. Ethernet is still better since it is true full duplex VS TDD(Time Division Duplex). As long as you do not mind the 3.5 ms latency introduced by Moca 2, best option after Ethernet.
You would need to get MoCA adapters.
Motorola MoCA Adapter for Ethernet Over Coax 2-Pack, 1,000 Mbps Bonded 2.0 MoCA (Model MM1002) https://www.amazon.com/dp/B078HMDDVS/ref=cm_sw_r_cp_api_i_OKl0Cb1H4H2XB
The SVG2482AC is a gateway (modem and router combo) with MTA capability for Comcast phone service. Do you subscribe to phone service? If not, you do not need nor want a device like that .
If you have a suitable router and just need a standard modem, get one off Comcast's approved list and add a standalone MoCA kit:
https://www.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/
My motorolas came with a filter each. Check the included accessories. It may be included. these are the ones I bought
yeah mesh is nothing more than a fancy wireless that provides better coverage but just like any wifi it is dependent on the structure of your home (ie walls , distance etc) so some have great coverage with mesh while others....well they do not.
I think you got it right. MOCA basically injects internet signal from your router into the coax. SO you need 1 poe filter to stop moca from broadcasting your internet through the coax outside the home to the whole neighborhood. you need 2 adapters one hooks up to the modem and router and lastly one adapter in the room where u have the other coax cable and u want internet. The amazon 2 pack adapter is perfect because it comes with a POE filter and its all u need .
Heres everything u need
https://www.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/ref=sr_1_3?keywords=moca+adapter+2+pack&qid=1554325788&s=electronics&sr=1-3
edit: you can also add several adapters where u have an unused coax. Also if you need both wifi and wireless you can get a unifi uap pro access point and hardwire it to the moca. Then have the second port on the access point going to your computer thus hardwiring it and also have wifi in that room from the access point. Thats how i have mine set up... just a thought if you need better wifi and a wired connection
Yes, I use this exact setup for mine. Main puck is downstairs in the living room (where Frontier put our FiOS ONT) with a connection to the upstairs puck via MoCA adapter/coaxial cable. This is the adapter set that I use with no issues: Motorola MoCA Adapter Set
Yes, MoCA allows you to send ethernet signals through coax. For ~90% of people it's pretty much plug it in and it works (assuming the coaxial cables actually all connected together through the locations you're interested).
----------------
If the TVs use regular cable, MOCA adapters work. DECA for DIRECTV and HIC for DISH.
One warning, regular moca adapters can be pricey (though they're basically full speed).
https://www.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/
DECA is dirt cheap but only supports up to 100mbps.
https://www.amazon.com/DIRECTV-Broadband-DECA-Ethernet-Adapter/dp/B00ZDUQVFU/
-------
As far as "get a new router" most people on here will suggest wireless access points like the TP-Link EAP225. They ONLY do wifi but they do it well. They also support PoE (power over ethernet) so you don't need to worry about getting a power cable to it if you are able to run ethernet (read: easier to get it in a good, central location)
There's a good chance that the house was wired for cable TV so I'd recommend the MoCA option as well. These Motorola adapters work great.
Yeah they can get expensive. Usually its used by most to bring internet between floors and not to use an adapter in every room.
I'm going to confirm my understanding -
Your set up is:
Modem+wireless router at one end of the house
wireless extender set up at another end of the house to receive a signal
powerline adapter at the other end, connected to the wireless extender
netgear powerline kit with wifi in your detached house
---------
I'm going to assume you're open to spending a little cash, have some time and are willing to get dirty. This should be MUCH higher performance/reliability but it's not as beginner friendly. The general idea is to wire as much as possible and to use point to point antennas instead of powerline (powerline is basically a big antenna that picks out interference from things like TV channels, people turning on vacuums, etc.)
---------
point to point wireless bridge:
https://www.amazon.com/Mikrotik-Wireless-RBwAPG-60ad-wireless-duplex/dp/B077992GG3
OR two MoCA adapters (works if you have coaxial cables run to the other house) https://www.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/
A few ethernet cables (cat6 - if you have anything that's going outdoors, get outdoor rated). I'd probably buy preterminated and go longer than you need.
a wireless access point - Ubquiti AC lite works
----
general idea - set up two units, while connected with wires to the main network, get an ethernet cable to an edge of your house (might require running in an attic or under the house, drilling a hole in the roof of a closet and then down from a soffit in usually works well); set up an AC lite while in the house; get one bridge unit and the AC lite mounted at the guest house. If you have coaxial cables already run, use MoCA units instead of a wireless bridge.
Net result should be GOOD wifi to the guest house.
You should hardwire the server even if its the only thing hardwired. If your house does not have Ethernet installed and you do not want to run cables i have used the MoCA devices and they are pretty good https://www.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/ref=sr_1_4?keywords=mocha+ethernet&qid=1555094926&s=electronics&sr=1-4 . Don't confuse MoCA devices with those terrible power line networking devices.
Sounds good!
I believe you're talking about this Motorola MoCA adapter?
One review suggested the Actiontek brand instead, due to some issues with the Motorola. There's about a $32 difference, so I'll have to see if that's justified.
Funny that Moto just went up in price by about $20 just a couple months ago after being at the $118 price point for almost a year!
Now I just need to figure out how and when to use the MoCA filters. If it's required that I plug one on the outside of the house (where the cable box is), that's not something I can do. If it's inside the home, I can do that.
I used MoCa due to the fact I didn't want to have cable running along the inside my house and did not want to spend the time fishing/wiring behind the walls. I bought a two pack of these: MoCa Adapters (2-Pack) and it works great. I get my full speed from Comcast (200down, 5 up) with no issues when online gaming. Can't hurt to try as you could always return it if you don't like it.
https://www.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/ref=sr_1_3?keywords=moca+adapter&qid=1550877832&s=gateway&sr=8-3
Here is a two pack that would get you started: https://www.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/
You can also get single MM1000 units if you want to add additional APs.
You need one MoCA adapter where your router is and one at each AP.
If you'd like to stick with a brand name but $170 is too steep for the ECB6200K02 kit, consider the Motorola MM1002 kit for $118.
I'm sure they're all using the same Broadcom BCM6802 chips but with different designs and build quality.
Does the modem have a co-ax connection? If so, look at MoCA if the house is already wired with cable co-ax to the rooms you want to use. You then run your network over the co-ax.
https://en.wikipedia.org/wiki/Multimedia_over_Coax_Alliance
These in each room with coax to give RJ45 connector:
https://www.amazon.com/Motorola-Adapter-Ethernet-2-Pack-MM1002/dp/B078HMDDVS/ref=sr_1_9?s=electronics&ie=UTF8&qid=1550682038&sr=1-9&keywords=coax+to+ethernet
Thanks for the super direct input here. A couple questions:
Sounds fine.
MOTOROLA MoCA Adapter for Ethernet Over Coax 2-Pack, 1,000 Mbps Bonded 2.0 MoCA (Model MM1002) https://www.amazon.com/dp/B078HMDDVS/
This is the standard now. I’ve used them. I get gigabit speeds, they’ve been great.
If you have a coax in your room, get this.
MoCA works great if you have coax in the right places (and it isn't carrying satellite—ordinary cable is OK). We use these and it makes a great link between floors.