Reddit reviews Vallejo Plastic Putty, 20ml
We found 5 Reddit comments about Vallejo Plastic Putty, 20ml. Here are the top ones, ranked by their Reddit score.
20ml plastic bottleDries to a white, totally opaqueStone hard finish
I used this for Glue https://www.amazon.co.uk/Gorilla-Glue-4200101-Epoxy-Syringe/dp/B01MQMM3X1 and this for the filler https://www.amazon.co.uk/Vallejo-20-ml-Plastic-Putty/dp/B000TSBJEO
I have not had any luck with green stuff so far, but I am loving plastic putty. I think it is easier to use for basic stuff like this, but I say this as a novice.
Vallejo Plastic Putty, 20ml https://www.amazon.com/dp/B000TSBJEO/ref=cm_sw_r_cp_tai_9bfJDbBRE0B47
So Ive used Green Stuff, Liquid Green Stuff, and now Vallejho's Plastic Putty, and by far my favorite to use is the Plastic Putty. Green stuff you have to kinda work with a little to get it to behave, but the Plastic Putty gets right in that crack thanks to the needle tip squeeze tube it comes in, and it seals really good too!
https://www.amazon.com/gp/product/B000TSBJEO/ref=oh_aui_detailpage_o09_s00?ie=UTF8&psc=1
Try Vallejo plastic putty https://www.amazon.com/Vallejo-VJ70401-Plastic-Putty-20ml/dp/B000TSBJEO.
It's water soluble in the initial stage, so you can wipe the excess away with a wet cotton swab.
Most of the time, the mating surface shouldn't be completely flush anyway. If two plates were welded or riveted together, they obviously won't be completely flush. Basically, don't be a perfectionist.
The putty is for filling small visible gaps. However, if you find numerous gaps in the finished model, you should probably consider buying a different brand...
Same goes for the injection pin marks. Good companies will design the model so that these marks are either facing inward or being covered up by other parts. You shouldn't need to fill more than a couple of these marks in a model. Otherwise, you should consider buying other brands.
I think most people would use something like Vallejo Plastic Putty:
https://www.amazon.co.uk/gp/product/B000TSBJEO