Best automotive intake manifold gaskets according to redditors
We found 5 Reddit comments discussing the best automotive intake manifold gaskets. We ranked the 3 resulting products by number of redditors who mentioned them. Here are the top 20.
We found 5 Reddit comments discussing the best automotive intake manifold gaskets. We ranked the 3 resulting products by number of redditors who mentioned them. Here are the top 20.
I've used the red Permatex many moons ago and it had no issue. Your biggest issue will be keeping it uniform so you don't end up making yourself more problems.
do you need to take it on and off a whole lot? if you don't just go with gasket tack to keep it stuck in the right places. or go with sheet gasket like this https://www.amazon.ca/Fel-Pro-3060-Gasket-Material/dp/B000CNKUGO and make yourself some kick ass gaskets.
Here ya go brother.
http://www.amazon.com/Fel-Pro-3060-Gasket-Material/dp/B000CNKUGO#searchKeyword
That should get you started
You can literally make gaskets out of cereal box cardboard in a pinch. You pretty much cant go wrong as long as you get something rated for automotive use you can use it nearly everywhere on the bike if you wanted to. I started out by buying an assortment of smaller sheets like THIS and then used whatever matched the original as closely as possible. When you run out of your assortment, you can run down to your local automotive parts store and get a replacement roll of the one(s) you used up the quickest, and those will last you a long time if you're just using them for personal use.
I replaced my crummy Dorman manifold with the Ford Racing part last week.
The Ford Racing unit comes with the gasket on top for the throttle body, does not need any separate hardware. No spacer needed.
It does need separate gaskets that sit on the intake ports on the heads, though. I got the Fel Pro one:
(Fel-Pro MS96281 Intake Manifold... https://www.amazon.com/dp/B000HUQ6IS?ref=ppx_pop_mob_ap_share)
Let me know if you have any questions about the job. I did it last week on my ‘07 P71. Changed out a Dorman for the Ford Racing OEM one.
I replaced:
•••••••••
MAHLE Original B32573 Engine Oil... https://www.amazon.com/dp/B0184JRWN6?ref=ppx_pop_mob_ap_share
Mine is pissing oil.
•••••••••
I also replaced my number 3 ignition coil. Mine was bad. A mechanic did that one for me. It’s a pisser. 🤦🏻♂️
••••••••
If you need a good low-force torque wrench, I recommend this: TEKTON TRQ21101 1/4-Inch Drive... https://www.amazon.com/dp/B01M12284X?ref=ppx_pop_mob_ap_share
It’s only 1/4” drive, but it works very well. High quality.