(Part 2) Top products from r/MarvelLegends

Jump to the top 20

We found 26 product mentions on r/MarvelLegends. We ranked the 95 resulting products by number of redditors who mentioned them. Here are the products ranked 21-40. You can also go back to the previous section.

Next page

Top comments that mention products on r/MarvelLegends:

u/zodd06 · 1 pointr/MarvelLegends

https://www.amazon.com/Molotow-ONE4ALL-Acrylic-Metallic-127-306/dp/B0080ZVV1O/ref=sr_1_13?crid=1WJIRDHPNFJ33

​

the molitov markers are pretty good for that.

whatever paint you use just make sure it's acrylic.

​

if the hand is really stuck you just need more heat and to slowly work it out, but don't do too much too fast at once because you don't want to melt or modify the part.

boiling water for 5-10 seconds at a time until you start to feel that it's getting a little rubbery. it takes time and patience. you have to slowly "work it" out. you can also try a hair dryer or a heat gun (be careful with a heat gun, it will def melt plastic fast, so temper it.) . if possible maybe try somehow to concentrate the heat on the wrist joint but not so much the hand. if you can get that joint to expand it might come out easier. if the part gets too rubbery from too much heat and starts to stretch and you try to pull it out just stop and let it cool off.

​

good luck.

u/Beadpool · 2 pointsr/MarvelLegends
  1. It’s going to be hard to match skin tones. You’ll just have to experiment. Maybe watch some videos on glazing and wet blending. Just a couple techniques that might help get two close colors to transition a bit more seamlessly.

  2. Number of layers depends on how thin the paints are and which colors you’re painting over. When starting, it’s always best to take it slow. If the paint looks good enough to cover in one layer, it’s most likely not thinned enough. Don’t rush it. Let the paint dry thoroughly before applying an additional coat.

  3. https://www.amazon.com/Testors-Spray-Lacquer-Clear-Coat/dp/B009FF6DN4
    Depends if you want a glossier or dull finish, but something like this should be fine. Read reviews & directions. Shake well. Ventilate. Start spraying away from figure, then sweep over figure. Light coats and let dry THOROUGHLY before thinking about another layer. Mess this part up and it’s hard to go back.

    Hope this helps!
u/DarkCelestial · 2 pointsr/MarvelLegends

This is a good one
Disney Infinity 3.0 Edition: MARVEL Battlegrounds Play Set https://www.amazon.com/dp/B016LGYSRC/ref=cm_sw_r_cp_apa_i_jZOlDb46T7J76

u/StubbornKindOfFellow · 4 pointsr/MarvelLegends

Get this Superman figure. It's currently $12, but sometimes you can get it real cheap. I got it used on ebay for only $5. But it comes with this accessory that fits perfectly on Cyclops.

u/Erod1527 · 2 pointsr/MarvelLegends

This stuff. Holds its shape well and is plenty long enough. Depending on how long you want the web, take two stems or fold one in half to leave a small open loop on one end to fit around the wrist peg, and then twist and weave it together to make it look like a web line.

https://www.amazon.com/DECORA-Gauge-White-Floral-Package/dp/B010NLWZNA/ref=sr_1_9?keywords=White+Fabric+wire&qid=1567293625&s=gateway&sr=8-9

u/fatguymontaine · 3 pointsr/MarvelLegends

Sweet! I got it about a year ago from Amazon.com. To my knowledge there’s only the two versions. I believe it was this seller. It’s definitely the same box mine came in.

u/WhatTheFhtagn · 3 pointsr/MarvelLegends

https://www.amazon.com.au/Deluxe-Action-Figure-Bases-Pack/dp/B07L9Y8GH3/ref=mp_s_a_1_1?keywords=action+figure+stand&qid=1562991057&s=gateway&sr=8-1

I use them on my Marvel Legends. They're really good because you get two in a pack, and the base has multiple ports. The claw also has a spring so they get a really firm grip on figures. You might have to tighten the screws up a bit though, and because of the design the claw won't rotate.

u/i_of_the_squawk · 3 pointsr/MarvelLegends

FYI it's already up for pre-order HERE!

u/usuallyplaysdps · 3 pointsr/MarvelLegends

Velocity suit is up

Spider-Man Hasbro Marvel Legends Series 6" Collectible Action Figure Velocity Suit Toy, with Build-A-Figurepiece, Accessory https://www.amazon.com/dp/B07Z8KW3BK/ref=cm_sw_r_cp_api_i_DhSTDbNFH7A01

Mark III is up

https://www.amazon.com/dp/B07Z8L4T9H/ref=cm_sw_r_cp_awdb_t1_3FYTDb18DN54A

u/ZanzibarMufasa · 3 pointsr/MarvelLegends

Hasbro Marvel Legends Series Toys 6-Inch Collectible Action 6-Pack Alpha Flight 6-Pack, 6 Figures with Premium Design, for Kids Ages 4 and Up (Amazon Exclusive) https://www.amazon.com/dp/B07TDH8HB4/ref=cm_sw_r_cp_api_i_M.eyDbT86CQ93

u/JoesusTBF · 4 pointsr/MarvelLegends

The brand is Combination of Life, I buy them on Amazon.
https://www.amazon.com/dp/B01CSB0EI6

u/Avid-Collector · 3 pointsr/MarvelLegends

I use this for right now.
https://www.amazon.com/dp/B001KN12PI/ref=cm_sw_r_em_apa_i_7IiqDb6SEM09A

Top drawer for accessories (blaster effects, symbiote attachments, etc)
2nd for only weapons (guns. Lots of guns, swords, etc)
3rd for heads, hands and head accessories (ex: starlord headphones or jubilee sunglasses, etc)

Until I need bigger for more accessories I get.

u/Jason3671 · 1 pointr/MarvelLegends

I used this pen. Can’t find this on amazon.com so I gave you the link to amazon.ca which I ordered from

u/PrimeConduitX · 1 pointr/MarvelLegends

SH Figuarts Hulk is the best looking MCU Hulk in my opinion. But, I know how expensive it is and how risky it is to buy loose. I recommend the Diamond select as an alternative which is a tad cheaper but might find it even more cheaper loose on ebay

​

https://www.amazon.com/DIAMOND-SELECT-TOYS-Marvel-Select/dp/B006WYKZX0

u/latenohn · 5 pointsr/MarvelLegends

It’s from the first movie line. The scale is awful, but this pose works ¯_(ツ)_/¯

https://www.amazon.com/Thor-Destroyer-Action-Figure-W2/dp/B0049MPGFE

u/AxoronMarvel · 1 pointr/MarvelLegends

Marvel Spider-Man 6-inch Legends Series Evil Adversaries: Marvel's Electro https://www.amazon.com/dp/B010SFU0PG/ref=cm_sw_r_cp_api_i_y1ysDbYNGR2B9