Reddit reviews Gates 91107 Belt Tension Tester
We found 5 Reddit comments about Gates 91107 Belt Tension Tester. Here are the top ones, ranked by their Reddit score.
Country of Origin : ChinaThe Package Height of the Product is 1.0 inchesThe Package Length of the Product is 5.0 inchesThe Package Width of the Product is 1.38 inches
how about one of the belt tension tools
https://www.amazon.com/Gates-91107-Belt-Tension-Tester/dp/B000MUTAGS
https://www.amazon.com/Gates-91107-Belt-Tension-Tester/dp/B000MUTAGS
This is what I use for my cars timing belt but I'm not sure if it reads low enough for a 3d printer belt. Something similar may exist in a lower tension range as well for accessory belts.
https://www.amazon.com/Gates-91107-Belt-Tension-Tester/dp/B000MUTAGS/ref=sr_1_1?ie=UTF8&qid=1480705422&sr=8-1&keywords=krikit
https://www.amazon.com/Gates-K060950-Multi-V-Groove-Belt/dp/B000C2WL8K/ref=sr_1_2?ie=UTF8&qid=1480705799&sr=8-2&keywords=5060950
Whoops, it wasn't actually a wrench. I think these two will work
Cheap one
Expensive one
And also from the forum: "The FSM (factory service manual) specifies 110-158 for a used Alt/WP belt"
I'm actually doing this fix today among a few others. Good luck!
Like this?