Reddit reviews Gizmo Dorks 3D Print Removal Tool, 5-inch Blade

We found 3 Reddit comments about Gizmo Dorks 3D Print Removal Tool, 5-inch Blade. Here are the top ones, ranked by their Reddit score.

Simple tool to help remove 3D prints from print bedThin blade profile slides underneath prints5-inch flexible blade to reach different size printsOffset blade allows for a safer angle to protect print and print bedWood handle with grips for superior control

Check price on Amazon

3 Reddit comments about Gizmo Dorks 3D Print Removal Tool, 5-inch Blade:

u/robbob2112b · 2 pointsr/ender3

I use this... you can generally use a sawing motion to work it all over and start an edge..

https://smile.amazon.com/gp/product/B01DTLWVSU

If that doesnt work I have a very flexible putty knife sharpened very sharp....then put it as flat as you can on the bed and tap it with a hammer to lift an edge, then use the other tool...

u/PowerUpProps · 2 pointsr/3Dprinting

https://www.amazon.com/Gizmo-Dorks-Print-Removal-5-inch/dp/B01DTLWVSU

I have a couple of these, they work beautifully.

u/Thranx · 1 pointr/FlashForge

Gluestick. It works both to keep it to the bed AND to create a bit of seperation to pull it off.

Get a cake frosting spatula, aka print removal tool. I have this (https://www.amazon.com/Gizmo-Dorks-Print-Removal-5-inch/dp/B01DTLWVSU) but this is super popular as well (https://www.amazon.com/BuildTak-BT30185-Spatula/dp/B017XGEDOM/)

For that one you're having problems with now, heat the bed up to 90 let it sit for 5 min or so and you should be able to pry it off.