Reddit reviews OPT7 Aura Interior Car Lights LED Strip Kit-16+ Smart-Color, Soundsync, Door Assist, Show Patterns, and Remote-Accent Underdash Footwell Floor, 4pc Single Row

Aftermarket. The OEM parts were too expensive for my wallet.

Footwell lights: https://www.amazon.com/gp/product/B00OU5LOT2/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1

Door Sills: https://www.amazon.com/gp/product/B07S7M3FC1/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

I got this kit from Amazon.

It comes with 4 led strips, and fuse taps for a couple different sized fuses, along with an led controller, full function remote, as well as keychain remote. Hands down the best value I could find.

Wired up the fronts a few months back, but didn't have time to do the back seat along with the fronts (with 2 kids there isn't much time for anything)

To power: fuse tap on the drivers side fuse panel to F17. Ground to the bolt that is right in that same area. I also tucked the controller away in that same location with some 3m double sided adhesive.

Lights: drivers side was easy. Figure out where you want the lights (helps to plug them in and have them lit up so you can mess w placement til you find what you like) then 3m/zip tie/etc to the spot. Passenger side: I popped off the center console trim and ran the wires across that to reach passenger front foot well. Same thing...mess with placement, when good, attach.

For the backseat: pulled out rear seat cushion, and trim along the drivers side rocker panel up to the fuse box. Zip tie the cables together, and run along the channel that's right there, then along the front of the rear seat area just behind the cushion. End of the wiring terminates in the middle of the seats just behind center console. Put rear seat back in, climb back there and plug in led strips to find placement. Used a few dabs of hot glue to attach them to the bottom of the seat.

And that's that. This kit is so simple that it is really a painless install, you just gotta make sure you run the wiring neatly, and secure it along any runs to either the dash, another wire loom, etc, so it doesn't fall out. Tuck the excess up into the fuse panel and call it a day!

i just installed an opt7 aura kit, the control has an optional wire to hook into the dome light, i think its what your looking for.
for 45$ its pretty great, colors are quality the adhesive & kit is complete, just don't get psyched when you see the music matching button.
https://www.amazon.com/OPT7-Smart-Color-Strip-Interior-Lighting/dp/B00OU5LOT2

They also sell an underglow and wheelwell kit that i recall someone mentioning that they could be controlled together...

I added some extra footwell/under seat led's recently. It was super easy, just time consuming and can be annoying if you're a bigger guy/gal. I'm 6' and had a little trouble bending in strange ways to get into the pedal area to mount the box and one of the lights, as well as connect the fuses. It was then super easy to pull off the center console siding and run the cables into the back and across to the passenger side. I think it looks great. There is about 2" of visible cable in the back to account for the seats moving back and forth, but other than that I installed then in about 2 hours with no problems.

I used [this] (https://www.amazon.com/gp/aw/d/B00OU5LOT2/ref=mp_s_a_1_2?ie=UTF8&qid=1496207734&sr=8-2&pi=AC_SX236_SY340_QL65&keywords=opt7&dpPl=1&dpID=51s2zulxQbL&ref=plSrch) kit and I'm impressed with the build quality and everything else. The only issue is that you'll need to get a micro fuse adapter and either solder it or splice it into the power cable.

I'll update this post with some day and night pictures tomorrow night.

I purchased this and installed myself in the first month of owning:

OPT7 Aura Smart-Color LED Strip... https://www.amazon.com/dp/B00OU5LOT2?ref=ppx_pop_mob_ap_share

Very easy install and looove the added light (red/blue are my most common) while driving at night. Conveniently, you can change it on the fly to fit your mood! I installed all 4 strips, one for each floor well, wires are all hidden, and came with a relay tap so no need to bother with hard wiring or using a 12v other adapter 👌

[edited for spelling]

I found [these](OPT7 Aura Smart-Color LED Strip Interior Lighting Kit (4 Items) https://www.amazon.com/dp/B00OU5LOT2/ref=cm_sw_r_cp_api_VBjDybYB1D1R2) and I think I'm gonna pull the trigger. Out of all the kits, these have the best reviews and they come with a fuse attachment you just plug into the fuse box to have them on with ignition, etc. I was looking and apparently I can remove the panels to the side of your legs (right leg for driver and left for passenger) pretty easily and just run the wire through and then close it back up. Plug into the fuse box and done. They have some stupid sound sensing stuff, but you don't have to use it. You can steady any color, strobe, dim, or cycle through etc. Just a thought, but from what I've looked into for myself, these seem the most hassle free. I have a link to the workshop manual that explains how to remove these panels, but it's for a 14. But, I imagine those center panels didn't change much. Let me know if you need it. I'd have to get it from my laptop for you.

Forgot to mention, I have to get one with a dimmer. I tested if I would even like illumination so I bought a. couple of stick on LEDs and stick them in my footwells and it's pretty distracting, so I may end up running them only to the door being opened. Anyway just a thought if you're not 100% sure you want them, you can grab those stick on LEDs for like $2 to test it out first.