Reddit reviews Zoeller 30-0181 PVC Plastic Check Valve, 1-1/2 Inch
We found 6 Reddit comments about Zoeller 30-0181 PVC Plastic Check Valve, 1-1/2 Inch. Here are the top ones, ranked by their Reddit score.
1-1/2 slip x slip unionsFlapper bends over a radius to eliminate sharp 90-degree edgesCapable of vertical or horizontal installationSlip x slip for 4.3 PSI (10 feet of head) at 130°FDesigned to reduce water hammer
Plumber here, buy [this pump] (http://smile.amazon.com/Zoeller-Mighty-mate-Submersible-Sump-Pump/dp/B000H5PYR2/ref=sr_1_1?ie=UTF8&qid=1416936374&sr=8-1&keywords=zoeller+sump+pump) . They are very tough and last a long time. If your old on edoes not have a check valve, buy this one to go with your new sump pump.
What kind of pump is it? I had a 5 year old big box store tether pump that would wake the whole house. Upgraded to a Zoeller m53 which cost me $125 on Amazon and is whisper quite. Don't forget to add in a check valve, which it doesn't look like yours has.
These are what I bought:
http://www.amazon.com/Zoeller-Mighty-mate-Submersible-Sump-Pump/dp/B000H5PYR2/ref=sr_1_1?ie=UTF8&qid=1452683726&sr=8-1&keywords=zoeller
http://www.amazon.com/Zoeller-30-0181-Check-Valve-Inch/dp/B0009WD1L4/ref=pd_sim_60_1?ie=UTF8&dpID=41tvTOSrD7L&dpSrc=sims&preST=_AC_UL160_SR160%2C160_&refRID=1DQ4X69H0CMEEQG9T9PN
When you replace it you really need to add one of these
here
So what I would do is, remove that union, connect the check valve and PVC down to the pump (I'd drop in one in the sump). You'll need a threaded adapter on the pvc to the pump and any 45 or elbow as needed.
Super easy, need just a screwdriver to remove the old one. Its the thing mounted a bit higher in the PVC pipe. Get one that matches the size of the pipe. Here is one as an example.
https://www.amazon.com/Zoeller-30-0181-Plastic-Check-Valve/dp/B0009WD1L4
Thanks! That is the 1/2 HP pump I was looking at instead of the 3/4 HP one if I decided to go with a water powered backup solution. However, I think I may go with battery backup instead.
​
This Wayne WSS30V is 1/2 HP all-in-one combo with battery backup and also has an alarm built in. I think this is what I'm leaning towards at this point. I was also looking at that Mighty Max for the battery, or this Duracell Ultra Deep Cycle Battery for 12V Sump Pump if it's okay to use (let me know what you think).
​
I ordered one of these Zoeller PVC Plastic Check Valves. Do I need two on the combo unit, or is just one okay?
​
I have this Basement Watchdog Dual Float Sump Pump Switch with Controller on my current pump and was just going to transfer it over to the new one using the metal clamp it came with.
​
Any other suggestions or information is greatly appreciated. Thanks again for all your help!
One thing I would say that might help is to move the check valves lower. They should be very close to the pump itself. Yours are so high that a lot of the water that gets pumped up comes right back into the sump. So they work more and the water level stays higher.
Make sure they are working when you move them. If not or suspect get a Zoeller 30-0181
http://smile.amazon.com/Zoeller-30-0181-Plastic-Check-Valve/dp/B0009WD1L4