Reddit reviews Weld-On 4 Acrylic Adhesive - 4 Oz and Weld-On Applicator Bottle with Needle

Materials I had to buy:

• Computer fan ^((Two, actually, cause I kind of set the first one on fire a little bit..)^)
  
• Power switch
  
• Molex power supply
  
• Two 12x12x0.125 inch sheets of polycarbonate
  
• Weld On #4 Acrylic Glue
  
  Cost me about $50, plus some materials I had lying around. ($60 after that second fan)
  
  Hope this post is informative enough guide anyone else interested in making one of similar design.
  
  Video of it in action
  
  Edit: Also, huge thank you to rcombs and derinerkan of #XKCD on Foonetic IRC network for helping me troubleshoot the fan issue when I set it on fire, and helping me figure out what I did wrong.

I use Acrylic Solvent, it welds it together perfectly.
https://www.amazon.com/gp/product/B0096TWKCW/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1

Locate a local sign shop, ask if they have a routing table. This will provide clean cuts, and most can accommodate typical straight cuts or shapes easily with their CAD system. If the material is thin enough, scoring and snapping should work.

Also, I've recommend looking into the following weld-on product (https://www.amazon.com/Weld-Acrylic-Adhesive-Applicator-Bottle/dp/B0096TWKCW). It can "weld" polycarb as well, just research what "weight" glue you want and insure that it adheres to whatever design aspect of your project (aka weld-on is not intended for aquariums...etc)

As for lubrication, the design intention is more important here as to what would work best....

I'm looking into repairing a cracked 51, would this acrylic adhesive help me seal the cracks?

I trust my printing setup so I am ok with very long print times. and gluing smaller parts will overall take longer and PLA and acetone form a very weak bond so do not use it, a much better option is this - https://www.amazon.com/gp/product/B0096TWKCW/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

There are plenty of PETG solvents. Try http://www.amazon.com/Weld-On-Acrylic-Adhesive-Applicator-Bottle/dp/B0096TWKCW

Or you can use a mixture of 600mL nitromethane to 4L methylene chloride.

First: CHECK WARRANTY


Second: Acrylic Cement

[ Weld-On 4 Acrylic Adhesive - 4 Oz and Weld-On Applicator Bottle with Needle https://www.amazon.com/dp/B0096TWKCW/ref=cm_sw_r_cp_apa_LvTZAbVPP56XN ]

LOL I thoguht this was a joke reply, but I googled it anyway.
http://www.amazon.com/Weld-On-Acrylic-Adhesive-Applicator-Bottle/dp/B0096TWKCW

Is this basically super glue? There are plenty of glues that will glue what I need glued, but I'm mostly concerned with the ash left afterward. Do you know if this burns away clean?

It's an odd property for someone needing glue to ask for so I can't imagine any glue being made with this property intentionally.